Before cleaning, observe under the strong light in the clean room, it is found that the PET workpiece is covered with particles, and there are colloidal particles caused by cutting.

Dip the synthetic glue remover SynGC25 with a lint-free cloth and wipe it around.

It was found that the particles and rubber particles above had been wiped clean.

Repeat the test. Take a new workpiece with a dust-free cloth dipped in SynGC25, a synthetic glue remover, and wipe it around.

before wiping

discuss:

5.1 When wiping, pay attention to the rough surface of the cut edge, which will cut the dust-free cloth and cause the fibers to stick back.
5.2 After wiping with SynGC25, a synthetic adhesive remover, there will be a layer of mist-like surfactant remaining on the surface within about 3 to 5 seconds. Don’t worry about it, and it will evaporate and disappear after about 5 seconds.
5.3 When wiping with a dust-free cloth, it should be operated in a clean room to avoid scratches caused by falling dust.